Loading ...
Loading ...
Loading ...
7INSTALLATION
Fitting the anti-tilt plate & stabilising bolt
Cooker Stability
NOTE: To ensure cooker stability, both the anti-tilt plate
and stability bolt MUST be installed on all cookers
(electric and gas).
Installation Sequence
1. The cooker is delivered with the anti-tilt plate. Locate
the anti-tilt plate against the rear wall. If locating
between 2 cupboards, then fit the plate in the centre
of the space. If locating the cooker at the end of a
cupboard, then position the side of the plate 48mm
from the cupboard.
NOTE: If cooker cannot be located against rear
wall, move anti-tilt plate forward to suit.
2. Securely fix the anti-tilt plate to the floor with
appropriate fasteners.
3. Slide the cooker back into the anti-tilt plate so that
rear cover rests against the rear wall.
Then check the height and level of the cooker.
If required, pull the cooker back out and adjust the
levelling feet as required.
4. Cut the cable tie from the stability bolt.
5. Rotate the stability bolt 180 clockwise until it is
pointing to the left like the picture below.
6. The stability bolt should now be able to drop to
the floor.
7. Mark the position for the stability bolt on the floor.
8. Pull the cooker out and drill the bolt hole, using a
6.5mm masonry or wood drill. Minimum 30mm deep
for concrete.
9. Reposition the cooker back into place, then fit the
stability bolt into the drilled hole.
10. Connect gas and electricity supply (refer to
pages following).
11. Fit the kick panel onto the cooker.
48mm to side
of plate
5mm clearance
Rear cover
Anti-tilt
plate
Rear adjustable foot
Stability bolt
Kick panel
ΓΈ6.5mm drilled
location hole
Front adjustable feet
Installing splashback
Fit splashback to rear of hob with the two
screws provided
Loading ...
Loading ...
Loading ...