Loading ...
Loading ...
Loading ...
27
ELECTRIC RECESSED WALL OVEN
With the oven positioned in front of the cabinet opening, connect the leads extending from
the conduit to the junction box.
Check all connections to see that they are tight and have not become loosened during
transit.
After the above mentioned wire connections have been made at the junction box, secure
the oven unit to the cabinet with wood screws. Be sure to use the cabinet spacer with
the wood screw as a “washer” between the wood cabinet and the oven front frame.
POWER CONNECTIONS TO APPLIANCES
We suggest that you have the dealer where you purchased your new oven unit install it
or have them arrange installation by a qualified electrician. Installation must conform with
local codes. In addition, installation must conform with the National Electric Code NFPA70
latest edition.
Be sure electric power is OFF at the fuse (breaker) box until the unit is
installed and ready to operate. See appliance rating plate for maximum
K.W. and amperage ratings.
INSTALLATION
It is the responsibility of your installer to make certain that your oven unit is properly
installed. Situations caused by improper installations are not covered under the warranty.
Any expenses incurred due to such situations will not be paid by the manufacturer of the
appliance.
INSURE PROPER
GROUND EXISTS
BEFORE USE.
ELECTRICAL GROUNDING
INSTRUCTIONS
Appliances may be equipped with a three prong
grounding plug for your protection against shock
hazard and should be plugged directly into a
properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
Loading ...
Loading ...
Loading ...