Loading ...
Loading ...
Loading ...
6
UNDER CABINET INSTALLATION
Preparation before Installation
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does
not operate, check the circuit breaker or
house fuse. If the hood is still not working,
disconnect power supply and check the
continuity of all wire connections.
-
Peel protective film off the hood (if any).
-
For installing under the cabinet with recessed
bottom, attach 4-inch wide wood filler strips (not
included) on each side. (Figure 1)
-
Using reference on Page 13 to measure and
create access opening for electrical wires and
exhaust under the cabinet.
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to
protect cooktop and/or countertop from damage.
1. Remove the bottom casing or baffle
filters/stainless steel spacers if necessary;
arrange the electrical wires to run through the 1”
diameter hole on the top or the rear of the hood.
2. Using references on Table 1 and measurements
on page 13, center the hood in place beneath the
cabinet and flush with the front of the cabinet.
3. Draw electrical wires through cabinet access
opening.
4. Use electrical drill to remove the knockout holes
on top of the range hood.
5. Place screw (provided) into the exact center of
each knockout hole. Make sure all screws are in
place before tightening screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 1
Loading ...
Loading ...
Loading ...