Loading ...
Loading ...
Loading ...
8
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs Remote CradleRemote
Installing the Glass
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Assembling the Light Kit
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Feed the wire plugs
through the center hole of
the upper switch housing,
then wrap keyhole slots
around the screws and twist
counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 6
Light Kit Screw
BAG
1 of 6
Light Kit Screw
BAG
1 of 6
Light Kit Screw
BAG
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Turn the light kit counterclockwise until the
light kit screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
2 of 6
Light Kit Screw
BAG
Loading ...
Loading ...
Loading ...