Loading ...
Loading ...
Loading ...
End of Cycle Signal 1.
The End of Cycle Signal produces an audible sound when the
drying cycle is finished, Promptly removing clothes at the end of
the cycle reduces wrinkling.
ON
!
ENDOF I
CYCLESIGNALI
Hold3 secondsto _1 2.
L0ck/Unl0ckControl
Press and release the END OF CYCLE SIGNAL to turn off the
signal,
Hold the END OF CYCLE SIGNAL for 3 seconds to lock or unlock
this control.
NOTE: When the WRINKLE SHIELD TM feature is selected and the
End of Cycle Signal is on, an audible sound will be emitted every
5 minutes until the clothes are removed, or the WRINKLE
SHIELD TM feature is finished.
You can change Auto Cycles, Timed Cycles, Modifiers and
Options anytime before pressing Start.
• Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1. Press STOP twice. This ends the current cycle.
2. Select the desired cycle and options,
3. Press and hold START.The dryer starts at the beginning of
the new cycle,
NOTE: If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected
Modifier or Option begins,
1. Press STOP once.
2. Select the new Modifier and/or Option.
3. Press and hold START to continue the cycle,
NOTE: Ifyou happen to press Stop twice, the program clears and
your dryer shuts down, Restart the selection process.
Use the Drying Rack to dry items such as sweaters and pillows
without tumbling. The drum turns, but the rack does not move.
If your model does not have a drying rack, you may be able to
purchase one for your model. To find out if your model allows
drying rack usage and for ordering information, please refer to
the front page of your manual or contact the dealer from whom
you purchased your dryer.
NOTE: The rack must be removed for normal tumbling. Do not
use the automatic cycle with the drying rack.
To use the drying rack
Do not remove the lint screen.
Open dryer door.
A. Front edge
Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.
o//
A. Dryerrack front edge
B.Dryerback panel
3. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
°#/
4. Close the door.
5. Press the POWER button.
6. Select a timed drying cycle and temperature (see following
chart). Items containing foam, rubber or plastic must be dried
on a clothesline or by using the Air Only temperature setting.
7. You must select a time by pressing TIMING Up or Down.
Reset time as needed to complete drying. Refer to the
following table.
8. Press (and hold) START button (about 1 second).
This chart shows examples of items that can be rack dried and
the suggested cycle, temperature setting and drying time. Actual
drying time will depend on the amount of moisture items hold.
Rack Dry Setting Temp. Time*
Wool Sweaters Timed Low 60
Block to shape and lay flat on Dry
the rack.
Stuffed toys or pillows Timed Low 60
Cotton or polyester fiber filled Dry
Stuffed toys or pillows Timed Air Only 90
Foam rubber filled Dry (no
heat)
Sneakers or canvas shoes Timed Air Only 90
Dry (no
heat)
*(Minutes) Reset time to complete drying, if needed.
23
Loading ...
Loading ...
Loading ...