Loading ...
Loading ...
Loading ...
Operating Your Heater
HEATER CONTROL
Ensure heater is on a flat, stable, heat-resistant surface. Once the heater is in a safe operating
position and all switches are in the off position, insert the power plug into the mains outlet.
Turn the Power Switch at the back of the heater to the 'I' position. The heater is now in
STANDBY mode.
The heater can be operated by the touchscreen control panel, remote control or via the Goldair
App. When an operation has been selected, the relevant LED light on the control panel will
display.
Turn the heater ON/OFF while in STANDBY mode. The LED light will display the current
room temperature and begin to blow out room temperature air in FAN mode. Touch
ON/OFF again to turn unit OFF. To assist in protecting the internal components, when the
unit is turned OFF the fan will continue to blow room temperature air for a period of 30
seconds before shutting down to standby.
DO NOT TURN OFF AT THE MAIN POWER SWITCH OR THE WALL DURING THIS TIME.
TEMPERATURE: Increases the desired temperature in 1℃ increments between 15-45℃.
On the remote control, use the up and down arrows to adjust the temperature.
MODE: Change the mode between Low heat, High heat and Fan. On the remote control,
use the button to cycle through the modes.
Display window
Touch sensor buttons
Turn on the power switch and the heater will enter STANDBY mode and the ambient (room)
temperature will display. Please note that the heater temperature may have a discrepancy due to the
air surrounding the heater being hotter than the room. For an accurate room temperature reading,
place an independent thermostat in your room.
Remote Control
Loading ...
Loading ...
Loading ...