Loading ...
Loading ...
Loading ...
15
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT
ALTERNATING CURRENT TOOLS
Tool’s Ampere Rating Cord Size in A.W.G Wire sizes in mm
2
Cord length in feet
25 50 100 150
Cord length in meters
15 30 60 120
3-6
6-8
8-10
10-12
12-16
18 16 16 14
18 16 14 12
18 16 14 12
16 16 14 12
14 12 - -
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
1.0 2.5 4.0 -
- - - -
TROUBLE SHOOTING
Problem Cause Remedy
Tool will not start. 1. Power cord is not plugged in.
2. Power source fuse or circuit
breaker is tripped.
3. Cord damaged.
4. Burned out switch.
1. Plug tool into a power source.
2. Replace the fuse or reset the
tripped circuit breaker. (If the
product repeatedly causes
the circuit or fuse to trip/blow,
discontinue use immediately
and have the tool serviced by
an Authorized SKIL Service
Center or Service Station.)
3. Inspect the cord for damage.
If damaged, have the cord
replaced by an Authorized
SKIL Service Center or Service
Station.
4. Have the switch replaced by an
Authorized SKIL Service Center
or Service Station.
Tool does not come up to
speed.
1. Extension cord has
insufcient gauge or is too
long.
2. Low house voltage.
1. Replace with adequate
extension cord (Refer to the
part of “EXTENSION CORDS”).
2. Contact your electric company.
Excessive vibration. 1. Accessory being used is bent
of damaged.
2. Accessory being used is not
secure in chuck.
1. Discard and replace with new
accessory.
2. Reference the “Inserting Bit”
section of manual.
Accessory binds, stalls
motor or kicks back when
drilling.
1. Damaged accessory.
2. Incorrect accessory for drill/
hammer drill speed.
1. Discard and replace with new
accessory.
2. Use properly rated accessory
as indicated by accessory
manufacturer.
Loading ...
Loading ...
Loading ...