Loading ...
Loading ...
Loading ...
GENERAL OPERATION
WARNING
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the begin-
ning of this manual including all text under subheadings therein before set up or use of
this product.
1. Switching on – press the switch button (2) and hold it down.
2. Switching off – release the switch button (2).
3. Switch lock (continuous operation).
a. Switching on: Press the button switch (2), and then press the switch lock button (3).
b. Switching off: Press and release the switch button (2).
4. Attaching nozzle:
a. Connect to two nozzle pieces (5) and twist to lock
b. Connect the nozzle assembly (5) to the blowing connector (1)
c. Rotate it to lock it in place
5. Adjusting speed:
a. Set Variable Speed Knob (6) to 1
b. Plug in blower and pull trigger.
c. Adjust the speed by turning the Variable Speed Knob (6) clockwise from 1 to
6 depending on desired output level.
6
• Work only in daylight or good artificial light.
• Avoid sucking in water or other liquids.
• Always make sure that your legs stand firmly on a slope.
• Walk, never run.
• Pay particular attention when changing direction.
•
When moving the tool from one work area to another, turn it off and unplug it between uses.
• Do not use the tool, if the nozzle is damaged or not attached.
• Make sure the vents are free from dirt, debris or other blockages.
• Before starting the tool, make sure that you are firmly holding the tool handle.
• Unplug the blower during any of the following:
- Every time you walk away from the device
- Before inspecting, cleaning or repairing the device
- After the device has been struck by a foreign object - check if it is broken
- If it begins to vibrate excessively
- If it overheats, smokes, or makes unusual noises
PREPARATION
Loading ...