Loading ...
Loading ...
Loading ...
12
PLUMBING & ELECTRICAL CONNECTION
Install the drain hose support to the
back wall, as close to the underside of
the countertop as possible. Refer to
'Plumbing & electrical considerations' for
minimum install heights.
Pull the hose through the support guide
and rest in standpipe.
Ensure the drain hose does not extend
into water retained in the trap; an air
gap is required to prevent waste water
from siphoning back into the tub.
Plug product in.
Ø38MM STANDPIPE INSTALLATION
1
2
3
4
Ensure the rubber washer is fitted to the
coupling before connecting the inlet hose
to the tap. Hand-tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
Dishwasher must be powered on for the
flood protection feature to be enabled.
Install the drain hose support to the
back wall, as close to the underside of
the countertop as possible. Refer to
'Plumbing & electrical considerations' for
minimum install heights.
Pull the hose through the drain hose
support before threading the wire clip
onto the hose and fitting to the supplied
hose joiner. Secure using the wire clips.
Ensure hose is routed straight to the
joiner, remove any excess drain hose.
Do not shorten the inlet hose. Unplug or
drill out the waste tee before securing
joiner to sink trap or waste tee.
Plug product in.
SINK TRAP/WASTE TEE INSTALLATION
1
2
3
4
Ensure the rubber washer is fitted to the
coupling before connecting the inlet hose
to the tap. Hand-tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
Dishwasher must be powered on for the
flood protection feature to be enabled.
Loading ...
Loading ...
Loading ...