Loading ...
Loading ...
SETUP
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside
door. Insert 4 “AA” batteries (included). Ensure the
batteries are installed in the correct direction, with
regard to polarity (+ and -) See diagram.
2. Replace the battery cover.
3. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn knob left to put locking door bolts in lock position.
2. Remove override key and store in a secure place.
NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: “1”-“5”–“9”-“E”.
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1. With door open, press reset button (C) inside
door.
2. Yellow light is on, enter new pass code in 30
seconds.
3. Enter new code (3 to 8 digits) followed by “E”.
Press “C” to clear entry if wrong digit is entered.
4. Safe will beep and yellow light will turn off.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code followed by “E”.
2. Green light will turn on.
3. You will have 5 seconds to turn door entry knob to the right and
open door.
TO CLOSE THE SAFE
1. Close the door and hold it in the closed position.
2. Turn door entry knob to left to engage the lock bolts and lock safe.
2
Loading ...
Loading ...
Loading ...