Tripp Lite BHDBT-K-PI Owner's Manual

Loading ...

Installation

12. If you are using a remote control on the transmitter side of the installation to

control a device on the receiver side (such as a TV), connect the IR-OUT cable

(with green 3.5 mm connector) to the IR-OUT port on the remote receiver unit.

Note: The IR-OUT unit receives the signal from the remote control on the other end of the

installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close

to the remote-controlled device (e.g. Blu-ray player, TV).

13. Connect the three 10/100 Ethernet ports on the receiver unit to your devices

(e.g. monitor, etc.) and/or a LAN.*

14. Connect the external power supply to the remote receiver unit and plug it into a

Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution

Unit (PDU). Models that support PoE will not require power at the receiver.*

15. Turn on the power to the HDMI source and RS-232 serial source.

* See the HDBaseT Features Chart on page 3 of this manual for the features your product supports.

18-11-131-933493-EN.indd 8 11/15/2018 10:31:46 AM

Loading ...

Tripp Lite BHDBT-K-PI HDBaseT Class B HDBaseT-Lite HDMI over Cat5e/6/6a Extender Kit, Power & IR Control, 4K x 2K 30 Hz UHD 1080p 60 Hz, Up to 230 ft. 70 m, TAA