Loading ...
Loading ...
Loading ...
10
ENGLISH
RDNet CONNECTION
The system is equipped with an RDNet connection on board.
Using an RDNet controller unit it is possible to:
- receive status information from the system (amplifiers status, signal levels, system
settings,…).
- Send commands to the system (mute, solo, change sensitivity, change setting, set user
eq, …).
- See the RDNet user manual for details.
RDNet BY-PASS SWITCH
When the RDNet is present and the RDNet LINK LED is green the controller takes control
over the module independently of the BY-PASS SWITCH position.
When the RDNet is not present, the BY-PASS switch act as follow:
- BY-PASS SWITCH pressed (LED ON): the system bypass the input board and reads
the RDNet user settings (last configuration saved).
- BY-PASS SWITCH released (LED OFF): the system reads the input board and bypass
the user setting eventually loaded ion the speaker (last configuration eventually saved).
TTS56-A DEFAULT CONFIGURATION
The TTS56-A factory default configuration (the configuration that the system reads if
the BY-PASS switch is pressed) is the following:
Sensitivity +4 dBu
High pass 30 Hz
Low pass 90 Hz
Cardioid OFF
Delay 0
Bypass OFF
User filters ALL FLAT
If the user set with RDNet a new configuration, the new configuration will be recalled
when the BY-PASS switch is pressed.
BY-PASS SWITCH RDNet BY-PASS LED FUNCTION
ON ON ON Reads RDNet settings
OFF ON OFF Reads RDNet settings
ON OFF ON Reads last saved used configuration
OFF OFF OFF Reads input panel
RDNet
RDNet CONNECTION
RDNet BY-PASS SWITCH
TTS56-A
DEFAULT CONFIGURATION
Loading ...
Loading ...
Loading ...