Loading ...
Loading ...
Loading ...
6
Read and understand the entire
contents of this manual before attempting set-
up or operation! Failure to comply may cause
serious injury.
5.0 Setup and assembly
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the machine is assembled
and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
5.1 Shipping contents
1 Electric Pinch Roll Bender
1 Combination wrench 22mm
9 Spacers:
2 1mm spacers with keyway
2 2mm spacers with keyway*
2 5mm spacers with keyway
1 1mm spacer without keyway
1 2mm spacer without keyway*
1 5mm spacer without keyway
1 Operating Instructions and Parts Manual
1 Warranty Card
5.2 Positioning and cleanup
Remove any fasteners holding machine to pallet,
and use a forklift or hoist with straps to carefully
move machine into position. Place straps around
handle, as shown in Figure 5-1. Lifting equipment
must be properly rated for weight of machine.
Figure 5-1
Position machine so there is enough room on all
sides for general maintenance and feeding of
materials. Anchor machine to a stable floor,
preferably concrete, using lag screws or other
appropriate fasteners through the holes in base.
Level the machine; use shims if needed.
Exposed metal surfaces have been given a
protective coating. Remove this with a soft cloth and
a cleaner-degreaser. Do not use gasoline, paint
thinner, acetone, etc., as these may damage
painted surfaces. Do not use an abrasive pad, as it
may scratch polished surfaces.
This machine may be used in vertical or horizontal
position (Figure 5-2).
Figure 5-2
For horizontal position:
Machine must be anchored
to floor. Failure to comply may cause
serious injury.
1. Open cabinet door and remove two socket head
cap screws (Figure 5-3).
2. Carefully move head to horizontal position, and
insert the two socket head cap screws into the
back holes, as shown. Securely tighten screws.
Figure 5-3
Loading ...
Loading ...
Loading ...