Loading ...
Loading ...
Loading ...
÷
Air Conditioner Features
(continued)
÷
DRAINAGE:
Power cord
w
Cover supplied
must be removed
Water pump
Fig. 10 drain hose
Power cord
\
Continuous
drain hose
/
Fig. 11
In the Cool & Dry Modes, water wilt collect in the internal bucket and wilt need
to be discharged.
Water Pump Drainage:
Remove the rubber cap from the spigot next to the power cord. Attach the rubber
tubing supplied to the drainage spigot. Locate the open end either through the rub-
ber grommet in the window slider kit so it can discharge out through the window, or
in a swtabb discharge drain. (Fig. 10)
The pump wHUengage once the bucket is fWk
Continuous Drainage:
Remove the supplied rubber stopper from the hose connector. Screw a suitable
length of hose onto this connector. Place the open end into a suitable drain making
sure there are no kinks in the hose. (Fig. 11)
Bucket Fult Indicator:
This may illuminate if the drainage methods above are not used or there are block-
ages within the drain hoses. If no drain hose method can be used, wheel the unit to
a suitable drain or outside, and then remove the continuous drain stopper to let the
internal bucket drain. If hose drainage is being used and no blockages or kinks can
be found then wheel the unit to a drainage point outside and drain as described
above. (Fig. 12)
Replace the stopper when drained.
A i¸ _ 0 l_ 0 _s \\\\
Temp _ 0 _@_i.m 0 Dry \\\
V o _, 0 _..... )
\\\\ 0 T#m'r 0
"-... On Off ........ /
_- Fig. 12
BUCKET FULL
INDICATOR
÷
REMOTE CONTROL
OPERATION:
_u_ .......................................................r_
V Temp A
FanSpe_d Time_Ol{
0 0
J
The remote control operates the unit in the same way as the controt panel
buttons with the exceptions noted betow:
AUTO FUNCTION:
The top left selection is an AUTO setting that will enable the appliance to determine
the best mode selection against the temperature you have set. It will then run at high
fan speed until the room is at the required setting, then the fan will slow down to keep
the temperature level.
If the mode is not comfortable, the desired mode can be selected manually.
Always have the exhaust hose attached in this mode.
The RESET button is depressed when you want to return to the initial factory settings.
The LOCK button is depressed to lock the keypad so the settings cannot be
changed. The key symbol wiii appear in the display for the remote. Depress again
to release.
Use a small pin to depress these buttons.
The remote can only display the set temperature in Fahrenheit. If you need to set the
room temperature in Celsius, use the control panel on the unit.
SZ000373( En)-YaoKong(p6-11 ) 9 _ 2004.11 8, 4:02 PM
Loading ...
Loading ...