TEF242BW1 Tappan electric range

User Manual - Page 6

For TEF242BW1.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Installation Instructions (continued)
To level the range:
I. Usea 1-I/4" open end key or an adjustable wrench to equally unscrew the four leveling legs
two to three turns each.
2. Install an oven rack in the center of the oven.
o 3. Move the range to its final position, then put a spirit levelon the rack to check for levelness.
Take two readings, one with the level placed diagonally first in one direction, and then the
other
4. Usethe 1-1/4" keyor wrench to adjust the leveling legs. Turn each one until the range stands
firm without wobbling.
5. Some models are supported by smooth glide rollers to facilitate moving.
If floor is flat and level, open the drawer and lower the front roller locking levers (some
models) to prevent the range from moving.
If floor isnot flat or level or if this model has rollers without locking levers, usethe 4 leveling
legsto level, support and prevent the range from moving.
Oven Light (somemodels)
Do not turn the oven light on during the self-cleaning cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven door is
opened.
The oven light may be turned on when the door isclosed by using the oven light switch located
on or underneath the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACEWHENEVER THE OVEN IS IN USE.
To replace the light bulb:
BE SUREOVEN ISCOOL.
I. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. Forself-cleaning oven, presswire holder to one side to releaseglass shield, change bulb and be sure to replace glass shield.
Surface Light (somemodels)
Be sure all surface element control knobs are turned off "Q" and
elements are cool.
Use switch located on or underneath the control panel to turn the surface light ON/OFF.
Replace the surface light, if after repeated attempts to turn it on you are not successful.
To remove and replace the fluorescent light:
I. Lift up the control panel cover.
2. Placeyour fingers on the tube at approximately 8" from each end.
3. To remove, turn the tube 90° then pull it out of its sockets.
4. To replacethe tube, engage the new tube into the sockets, then rotate and snap the tube in
place light to make it sure it will lit.
Loading ...
Loading ...
Loading ...