Loading ...
Loading ...
Loading ...
ThisOwner'sGuideprovidesspecificoperating
instructionsforyourmodel.Usethefreezeronlyas
instructedinthisUse&CareManual.Beforestarting
thefreezer,followtheseimportantfirst steps.
LOCATION
• Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug.
• For the most efficient operation, the freezer should be
located where surrounding temperatures will not drop
below 40°F (5°C) or exceed 110°F (43°C).
• Allow the following clearances for ease of installation,
proper air circulation, and electrical connections:
Sides 3/8"
Back & Top 1"
• Do Not block the toe grille on the lower front of your
freezer. Sufficient air circulation is essential for the
proper operation of your freezer.
J
Freezer
Installation
DOOR OPENING
LEVELING
The freezer must have all bottom corners resting firmly on
a solid floor. The floor must be strong enough to support
a fully loaded freezer. NOTE: It is Very Important for
your freezer to be level in order to function properly. If
the freezer is not leveled during installation, the door may
be misaligned and not close or seal properly, causing
cooling, frost,
or moisture
problems.
To Level
Freezer:
After discarding
crating screws PLASTIC LEVELING FEET
and wood
CRATING
base, use a SCREW
carpenter's
level to level
the freezer
from front-to-
back. Adjust the
plastic leveling
feet in front, V2 /J_Z _'
DISCARD THE (4) CRATING
bubble higher, SCREWSANO/_;woo0BASES
SOthat the door %
closes easily
when left halfway open.
Leveling Instructions for all Refrigerator/Freezer Pair:
• Remove two leg levelers provided in literature bag.
While unit is lying on its back for wood skid removal,
install both leg levelers in rear of unit.
• Level door of first unit using all four levelers and slide
unit into place. Recheck for levelness and adjust if
necessary.
Measure distance from floor to bottom of door on
first unit. Adjust and level second unit so door height
matches.
• Leg Level Adjustments
- One full turn of all four leg levelers will raise door
5/32".
- One full turn of both front leg levelers will raise
door 3/16" and tilt top of door back 7/16".
- One full turn of both rear leg levelers will lower
door 1/32" and tilt top of door forward 7/16".
- One full turn of both side leg levelers will raise
door 3/16" and tilt top of door 3/8".
Slide second unit into place leaving a minimum gap
of 3/16" between units for door swing clearance.
This last step may require at least one extraction of
the second unit to properly align units in a "built-in"
application.
Loading ...
Loading ...
Loading ...