Loading ...
Loading ...
Loading ...
The drain pump can operate
shortly before the appliance
fills water.
11.7 Starting a programme
with the delay start
1. Touch the Delay Start button
repeatedly until the display shows the
desired delay time. On the display
the indicator shows
2. Touch the Start / Pause button.
The appliance door locks and starts
the countdown of the delay start. The
display shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start / Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
and the indicator goes off.
3. Touch the Start / Pause button
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start / Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start / Pause button
again to start the new countdown.
11.8 The ProSense System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start / Pause
button, the maximum declared load
indicator goes off, the ProSense System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Save is available, during
this phase the Time Save bars
placed below the time digits play a
simple animation. The drum rotates
shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start / Pause
button to start
the programme again. The ProSense
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
www.aeg.com32
Loading ...
Loading ...
Loading ...