Ancona AN1506 36 Inch Stainless Steel Convertible Chimney Style Wall Mount Hood

User Manual - Page 14

For AN1506.

PDF File Manual, 22 pages, Read Online | Download pdf file

AN1506 photo
Loading ...
Loading ...
Loading ...
— 14 —
IMPORTANT:
• Observeallgoverningcodesandordinances.
• It is the customer’s responsibility to contact a qualified electrical installer.
• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat
thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp
circuit, fused on both sides of the line.
• DONOTgroundtoagaspipe.
• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
• DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged
into an outlet that is properly installed and grounded.
WARNING: Improper grounding can result in a risk of electric shock.
• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
Installation
STEP 13
Install Chimney
• Place chimney on top of the main housing and screw in with two screws (see Figure #4).
• Remove the protective coating from the upper chimney. Carefully slide the upper chimney down into the lower chimney.
• Use two screws to x the two chimneys together with the lower chimney bracket, make sure upper chimney is moving
freely (see Figure #5).
• Screw the upper chimney to the upper mounting bracket (see Figure #6).
Figure #5 Figure #6Figure #4
Loading ...
Loading ...
Loading ...