Loading ...
Loading ...
Loading ...
23
8. Screen maintenance
Following the characteristics of
OLED displays, there are automatic
mechanisms used to protect the screen
and reduce image sticking which may
request an opportunity to run the refresh
process. These mechanism settings may
be adjusted in the On-Screen Display
(OSD) menu under OLED Panel Care.
Resolution
3840X2160 60Hz HDMI 1 Off Standard
Refresh Rate Input Source Adaptive Sync SmartImage
Select
Power LED
Language
Resolution Notice
CEC
OLED Panel Care
Information
Reset
Screen Saver
Pixel Orbiting
Pixel Refresh
Panel Refresh
Auto Warning
On
On
No
No
On
OK
Back
SmartImage Game Mode Input Audio System Setup CloseAmbiglow
On
O
• Screen Saver
When a static image is detected for a
certain period of time, the screen saver
function will dim the screen to protect
the panel from sticking. When a moving
image is detected, the monitor will
recover luminance to previous working
status. Default setting is On and would
highly recommend that you always set
it as On to protect the screen. It is also
recommended that you also set your
device to use a screen saver.
• Pixel Orbiting
Pixel shift moves the image a couple
of pixels at regular intervals to avoid
potential sticking. This is not noticeable
in normal circumstances. Default setting
is On and would highly recommend that
you always set it as On to protect the
screen.
• Pixel Refresh
Pixel Refresh is activated when the
screen has passed accumulative usage
of over 4 hours. This is an eort to avoid
the image sticking on the monitor.
Before self-activating Pixel Refresh,
a pop-up message will appear after
the 4 hour time limit and the user can
choose to activate or skip the refreshing
process. If the user chooses to skip the
initial Pixel refresh, then a reminder
will appear every two hours. When the
cumulative usage time reaches 16 hours,
the screen will automatically refresh.
In addition, six countdown warning
messages will appear before reaching
the 16 hour time limit and will be
presented in the sequence of 10, 5 , 4, 3,
2, and 1 minute(s). it will automatically
refresh. You cannot skip the Pixel
Refresh process.
When Pixel refresh is activated, the
screen will go into standby mode for a
total of 6 minutes while it completes
the entire process and the LED indicator
will begin to blink on and o. After
the 6 minutes of standby mode is done
and the Pixel Refresh has nished, the
LED indicator will stop blinking. When
it is apparent that the Pixel Refresh has
nished, turn the monitor back on and
resume activity.
Please note that if it is not possible to
activate the Pixel Refresh upon receiving
the reminder, then it is possible to
program Pixel Refresh on the OSD menu
at a time that works best.
A reminder message that pops up after 4 hours of
continuous use, and will then appear every 2 hours
after.
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Yes No
Loading ...
Loading ...
Loading ...