Troy-Bilt 12A-566N063 Official Troybilt Lawn Mower

User Manual - Page 11

For 12A-566N063.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
SECTION6: MAINTAININGYOURLAWNMOWER
WARNING: Always stop the engine and
disconnect the spark plug wire before
performing any maintenance work or
adjustments on your lawn mower.
CleaningMower
The underside of the mower deck should be cleaned
after each use to prevent any build-up of grass
clippings, leaves, dirt, or other debris. If this debris is
allowed to accumulate, it will result in rust and
corrosion.
NOTE: We do not recommend the use of pressure
washers or garden hose to clean your unit. These may
cause damage to electric components, spindles,
pulleys, bearings, or the engine. The use of water will
result in shortened life and reduce serviceability.
Disconnect spark plug wire.
Drain the gasoline from the lawn mower, or place a
piece of plastic under the gas cap.
Tip the mower so that it rests on the housing. Keep
the side with the air cleaner facing up. Hold the
mower firmly.
Scrape and clean the underside of the deck with a
suitable tool. Do not spray with water.
Put the mower back on its wheels on the ground. If
you had put plastic under the gas cap, make sure to
remove itnow.
WARNING: Never tip the mower more than
90 degrees in any directions and do not leave
the mower tipped for any length of time. Oil can
drain into the upper part of the engine causing
a starting problem.
EngineCare
A list of key maintenance jobs required for good
performance by the mower isgiven below. Follow the
accompanying engine manual for detailed list and
instructions.
Change engine oil regularly, as instructed in the
engine manual. Check oil level before starting
engine every time.
Service air cleaner regularly. You may have to
service this more frequently ifyou are operating the
mower under extremely dusty conditions.
Clean the engine periodically. Remove dirt and
debris with a cloth or brush.
Clean the spark plug and reset the gap to .O3O"at
least once a season. Refer to the engine manual for
correct spark plug type.
Inspect muffler periodically, and replace if
necessary. Damaged mufflers or spark arrestors
can create a fire hazard.
WARNING: Avoid muffler and surrounding
areas while the mower engine is hot because
temperature of these areas of the engine may
exceed 150°F.
Lubrication
Lube
Lube
Lube
Figure 9: Lubrication Chart
Wheels
Lubricate the wheels and bearings, ifso equipped,
at least once a season with light oil or engine oil.
Also, ifthe wheels are removed for any reason,
lubricate the surface of the axle bolt and the inner
surface of the wheel with light oil.
MulchPlug& RearDischargeDoor
Lubricate the torsion spring and the pivot point on
each end of the rear discharge door using a light oil.
Transmission
The transmission is pre-lubricated and sealed at
the factory and does not require lubrication on a
regular basis as part of maintenance.
BladeControl
Lubricate the pivot points on the blade control
handle and the brake cable at least once a season
with a light oil. It needs to move in both directions.
11
Loading ...
Loading ...
Loading ...