1. Home
  2. PAC
  3. PAC AP4-GM61 User Manual
  4. Page 2

PAC Audio AP4-GM61 Amplifier Integration Interface for Select GM vehicles with Bose system

Instruction Manual - Page 2

For AP4-GM61.

PDF File Manual, 5 pages, Read Online | Download pdf file

AP4-GM61 photo
Loading ...
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 2
Rev: V3
Date:072618
Advanced Amplier Interface for
General Motors
AP4-GM61
Installation
1. Access the factory radio module (see location info in Figure 1, next page).
2. Disconnect the Gray 20-pin factory harness and the Gray 8-pin harness from the tuner module (Figure 2, next page).
3. Connect the AmpPRO harness to vehicle harness.
4. Connect the AmpPRO harness to factory tuner module.
5. Set any feature DIP switches that apply to your install.
a. DIP switch 1 is used for two channel mode. In this mode, both the TOSLINK and front RCA outputs (1 and 2) become
non-fading outputs. All rear chimes will also be routed through these outputs in two channel mode.
b. Set DIP switch 2 on (down) to lower the RCA output voltage to 4v. Leave DIP switch 2 off (up) to keep the RCA output
voltage at 5v. See the troubleshooting section on page 5 for more details.
6. Connect the AmpPRO harness to the module.
7. Connect the level control knob to the module and install in an accessible location.
8. Connect the signal cables and remote input from the aftermarket amplier.
9. Turn the vehicle off, shut the doors and lock the vehicle with the factory keyfob. Wait 5 minutes. After 5 minutes, turn
vehicle back on, and proceed with setup and conguration.
DIP
1 2 3 4
ON
Two Channel Mode 5v / 4v Preout No Function No Function
1 2 3 4
Set DIP switches to the ON position to activate the corresponding features.
Set DIP switches to the OFF position for any features that are not desired.
Module Layout
Interface Connector 1
Expansion Port
Programming Button
Feature Select
DIP switches
Non-Fading Level Control
Knob Connection
USB Connection
LED 1
TOSLINK Output
Front Output
Ch. 1(L) and 2(R)
Rear Output
Ch. 3(L) and 4(R)
Non-Fading
Output Ch. 6
LED 2
Center Channel
Output Ch. 5
Wiring Connection Chart
*Non-Fading
Front
1(L) 2(R)
4(R)
5 6
3(L)
Remote Turn On Output
2A Max Output
Rear
5-Center
6-NF*
TOSLINK
Optional
AP4-GM61-HAR
To Tuner
To Vehicle
Harness
Non-Fading
Level Control
Knob
To Aftermarket
Amplifier
Loading ...
Loading ...
Loading ...