Loading ...
Loading ...
Loading ...
Care&Cleaning
Removing and Replacing Storage Drawer with
Extendible Glide (some models)
To Remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Locate glide leveron each side ofdrawer, pull up on the left glide leverand push down
on the right glide lever (See Figure 1).
3. Pull the drawer away from the range.
To Replace Storage Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Pushthedrawerintotherangeuntillevers"click"(approximately2"). Pullthedraweropen
again to seat bearing glides intoposition. If you do not hear the levers "click" or the
bearing glides do not feel seated remove the drawer and repeat steps 1thru 3.This
will minimize possible damage to the bearing glides.
Pull down latch
with finger
Pull up latch
with finger
Removing and Replacing Warm & Serve Drawer
(some models)
'==_ _ Electrical Shock Hazard can occurand result in serious
injuryordeath. Disconnect appliance from electric power before cleaning
and servicing the warm & Serve drawer.
To Remove Warm & Serve Drawer:
1. _ Turn power off before removing the warm & Serve drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warm & Serve Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3.
Right Glide
Figure 1
_ng Glide
Figure 2
NOTE: The Warm & Serve Drawer will
NOT operate wNe inthe"Self-Clean"
and "Oven Lockout" modes
Push the drawer intothe range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into
position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the d rawer and repeat
steps 1 thru 3. This will minimize possible damage to the bearing glides.
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven
light on during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interioroven lightwill turn on automatically when the oven isopened. The oven light may be turned on when the
door isclosed byusing the oven light switch located on the Electronic Oven control. The oven light bulb iscovered with a glass shield
held inplace by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb: _ BE SURE OVEN IS COOL
t. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb
and be sure to replace glass shield.
' stir ' Your Oven Temperature
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
18
Loading ...
Loading ...