Loading ...
Loading ...
Loading ...
5=
To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser pad OR
press the water dispenser button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show how
much water remains to be dispensed. The display will turn off
after 15 seconds of inactivity.
To select a new volume or select the same volume again, you
must first finish dispensing the selected volume, or turn off
the Measured Fill feature and then turn it back on.
Rotating Faucet and Pull-out Tray (on some models)
Your dispenser may include a rotating water faucet and a small
pull-out tray at the bottom of the dispenser.
A. Faucet rotated
B. Pull-out tray
• The faucet rotates to the center to allow for easy dispensing
into large containers. To rotate it, push in and release the left-
hand side of the faucet as shown.
The faucet rotates to the center automatically. However, you
must rotate it back into place manually. When in place, it will
click.
NOTE: When using the dispenser with the faucet rotated, do
not use the water dispenser pad. Only use the water
dispenser button to dispense. Dispensing by pressing the
container against the water dispenser pad may result in
unintentional spilling.
The tray can be pulled out approximately 11/2'' (3.81 cm) to
better support large containers. It is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.
NOTE: The tray can be removed from the dispenser and
carried to the sink to be emptied or cleaned. Pull the tray out
until it hits the stop, then gently lift up on the back of the tray
and slide it out the rest of the way.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. The dispensing system will not
operate when the freezer door is open. To turn off the ice maker,
see "Ice Maker and Storage Bin."
Your ice maker can produce shaved, crushed and cubed ice.
Before dispensing ice, select which type of ice you prefer by
pressing the ICE SELECT button.
G
The display screen indicates which type of ice is selected.
* • • 4,Q
¢' 4,
"o ,° _.
SHAVED CRUSHED CUBED
For shaved or crushed ice, cubes are shaved/crushed before
being dispensed. This may cause a slight delay when dispensing
shaved or crushed ice. Noise from the ice crusher is normal, and
pieces of ice may vary in size. When changing from crushed to
cubed, a few ounces of crushed ice will be dispensed along with
the first cubes.
To Dispense Ice'.
1. Press the button to select the desired type of ice.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2=
3=
Press a sturdy glass against the ice dispenser pad OR place
the glass below the ice dispenser and press the ice dispenser
button.
Hold the glass close to the dispenser opening so ice does not
fall outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the pad or button in order to activate the ice dispenser.
Pressing hard will not make the ice dispense faster or in
greater quantities.
Remove the glass OR release the button to stop dispensing.
NOTE: Ice may continue to dispense for up to 10 seconds
after removing the glass from the pad or releasing the button.
The dispenser may continue to make noise for a few seconds
after dispensing.
14
Loading ...
Loading ...
Loading ...