Loading ...
Loading ...
Loading ...
5
6. Strip o 3/4 inch of insulation on the red and black wires to
expose the copper conductor. Combine and twist the red wires
from the amplier, the rst satellite and the wire running to the
next speaker in a clock-wise motion.
7. Secure these three wires using the provided silicone lled wire
nuts, ensuring that NO COPPER is exposed.
8. Wrap the wire nut and surrounding wire connection in electrical
tape to protect from moisture.
9. At the next speaker, repeat steps 2 – 7 for the left channel using
the white (+) and green (-) leaving the red (+) and black (-)
wires intact.
10.Continue the above steps for the remaining 6 speakers in the
daisy-chain (see Figure 3).
Connecting the Speakers Using a
2-Conductor Wire or Low Voltage
Lighting Wire
1. Pull the rst pair of 2-conductor wire to the furthest speaker
location, leaving it connected to the spool near the amplier.
2. Starting at the furthest speaker and every other speaker that
follows, create a loop of wire approximately 6” in length, securing
the loop with a wire tie.
3. Cut the wire at the last speaker location in the daisy-chain
closest to the amplier.
4. Take the spool back to the starting point and pull a second
2-conductor wire to the furthest speaker location and repeat
steps 1 and 2 (see Figure 4).
5. Starting with the rst speaker, cut the wire loop.
6. Strip the insulation on each wire to expose approximately 3/4”
of copper. Combine and twist all the positive (+) wires together in
a clockwise motion. Repeat this step for all the negative (-) wires.
7. Secure the three wires together using the provided silicone lled
wire nuts ensuring that NO COPPER is exposed (see Figure 5).
8. Repeat steps 5– 7 for the remainder of the speakers.
Figure 4
To speaker
To next speakerFrom amp
IMPORTANT: BE SURE ONLY 4 SATELLITE SPEAKERS ARE CONNECTED
TO EACH AMP CHANNEL; MIS-WIRING MAY RESULT IN AN
UNACCEPTABLE LOAD WHICH COULD DAMAGE YOUR AMPLIFIER.
NOTE: IF NOT USING COLOR-CODED WIRE, NOTICE THAT ONE OF
THE WIRES OUT OF THE PAIR WILL HAVE A DIFFERENT TEXTURE OR
PRINTING ON IT. THIS WILL HELP IDENTIFY AND SEPARATE THE (+)
FROM THE (-). FOR SIMPLICITY, USE THE WIRE WITH TEXTURE OR
WRITING AS THE (+) AND THE OTHER AS THE (-). USE THIS POLARITY
STANDARD WHEN CONNECTING ALL THE SPEAKERS.
Left Right Left Right Left Right Left Right
Left and Right
Loading ...
Loading ...
Loading ...