Loading ...
Loading ...
Loading ...
Positioning and connecting en
15
Tip: The following are available from
specialist retailers/our after-sales
service:
■ Extension for Aqua-Stop and cold
water supply hose (approx. 2.50 m);
order no. WMZ 2380, WZ 10130,
Z 7070X0
■ A longer supply hose (approx. 2.20
m) for standard models; individual
component number for the after-
sales service: 00353925
Water inlet
:Warning
Risk of electric shock!
The Aqua-Stop contains an electric
valve. There is a risk of electric shock if
you immerse the Aqua-Stop safety valve
in water. Do not immerse the safety
valve in water.
Notes
■ Only operate the washing machine
using cold mains water.
■ Do not connect the machine to the
mixer tap of an unpressurised hot-
water boiler.
■ Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
■ Do not kink or squash the water
supply hose.
■ Do not alter (shorten, cut through)
the water supply hose (otherwise, its
strength is no longer guaranteed).
■ Only tighten the screw connections
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
■ When connecting to a 21 mm = ½"
tap, first fit an adapter
*
with a sealing
washer from 21 mm = ½" to 26.4
mm = ¾".
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
■ Model: Standard
■ Model: AquaSecure
* supplied depending on the model
PLQPP
ê
ë
Loading ...
Loading ...
Loading ...