Loading ...
Loading ...
Loading ...
25
CARE AND MAINTENANCE
Cutters Chain Rotation
Chain Drive Links
Bar Groove
Chain Drive Links
6. Remove the old chain from the bar.
7. Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.
8. Place the chain drive links into the bar groove.
Note: Make certain of direction of the chain.
9. Position the chain so there is a loop at the back of
the bar.
10. Hold the chain in position on the bar and place the
loop around the sprocket.
11. Fit the bar ush against the mounting surface so
that the bar studs are in the long slot of the bar.
Ensure that the chain is over the sprocket.
Note: When placing the bar on the bar studs, ensure
that the adjusting pin is in the chain tension pin hole.
12. Replace the chain cover.
13. Remove all slack from the chain by turning the
chain adjustment screw (K) clockwise until the
chain seats snugly against the bar with the drive
links in the bar groove.
14. Lift the tip of the guide bar up to check for sag.
15. Release the tip of the guide bar and turn the chain
adjustment screw 1/2 turn clockwise. Repeat this
process until sag does not exist.
Loading ...
Loading ...
Loading ...