Loading ...
Loading ...
Loading ...
9 — English
WARNING:
Use only the nails recommended for use with this tool.
The use of any other nails can result in tool malfunction,
leading to serious injuries.
WARNING:
Never load nails with the workpiece contact or trigger
activated. Doing so could result in possible serious
personal injury.
SETTING THE AIR PRESSURE
See Figure 6, page 13.
The amount of air pressure required will depend on the size
of the nail and the workpiece material.
Begin testing the depth of drive by driving a test nail into
the same type of workpiece material used for the actual job.
Remove battery pack from the tool.
Turn air pressure dial clockwise to increase drive power
or counterclockwise for decreased power.
It may be possible to achieve the desired depth with air
pressure adjustments alone. If finer adjustments are needed,
use the depth of drive adjustment on the tool.
NOTE: Under some conditions, the unit may not deliver a
nail when the air pressure dial is turned to the MAXIMUM
pressure setting. The user may need to decrease the pressure
setting for desired operation.
DEPTH OF DRIVE ADJUSTMENT
See Figure 7, page 13.
The driving depth of the nail may be adjusted beyond air pres-
sure. It is advisable to test the depth on a scrap workpiece
to determine the required depth for the application.
To determine depth of drive, first adjust the air pressure and
drive a test nail. To achieve the desired depth, use the depth
of drive adjustment on the tool. Harder materials and longer
nails will require more force to drive the nail.
Remove battery pack from the tool, if installed.
Turn the depth of drive adjustment left or right to change
the driving depth.
Reinstall battery and reactivate the tool by pressing the
worklight grip switch.
Drive a test nail after each adjustment until the desired
depth is set.
NOTE: Set depth of drive at the shallowest depth that
will meet your needs.
USING THE MODE SELECTOR SWITCH
See Figures 8 - 10, page 13.
WARNING:
Never wedge or hold back the workpiece contact
mechanism during operation of the tool. Doing so could
result in possible serious injury.
This tool is shipped from the factory with the mode selector
switch set in the Single Sequential Actuation mode. The mode
selector switch can also be set for Contact Actuation mode.
SINGLE SEQUENTIAL ACTUATION MODE
Single sequential actuation provides the most accurate nail
placement.
Remove battery pack from the tool.
Slide the selector to position ( ).
WARNING:
The nailer will not function properly if the selector
is not securely seated in either position ( ) or
( ). Always assure the selector is seated properly to
avoid an unexpected nail discharge and possible serious
personal injury.
Reinstall battery and activate the tool by pressing the
worklight grip switch.
Grip the tool firmly to maintain control. Position the nose
of the tool onto the work surface.
Push the tool against the work surface to depress the
workpiece contact.
Squeeze the trigger to drive a nail.
NOTE: Hold trigger until drive cycle is complete. If depressing
the trigger does not drive a nail, release the trigger and lift the
tool away from the workpiece, then replace and try driving
the nail again.
Always remove your finger from the trigger when the
desired number of fasteners has been driven.
CONTACT ACTUATION MODE
Contact actuation allows very fast repetitive nail placement.
Remove battery pack from the tool.
Slide the selector to position ( ).
Reinstall battery and activate the tool by pressing the
worklight grip switch.
Grip the tool firmly to maintain control.
Squeeze and hold the trigger. Push the tool against the
work surface to depress the workpiece contact and drive
a nail. To drive another nail, lift the tool and press the
contact against the work surface again.
OPERATION
Loading ...
Loading ...
Loading ...