Loading ...
Loading ...
GASSPRINGSINSTALLATION
itemsNeeded:
GasSprings(Qty:2)
5/16- 18 Ball Studs (Qty: 4)
5/16 - 18 Clip-on Nut (Qty: 4)
1!2-in Wrench
PrOCeSS:
Install (2) 5/16-18 Ball Studs and (2) 5/16-18 Clip-on Nut
into slot on left and right side of cover. Tighten using 1!2-
in wrench.
.......................5/16- 18
5/16 - 18 ......
Clip-on Nut
Ball Stud
- Install (2) 5/16-18 Batt Studs into top tray using (2)
5/16-18 Clip-on Nut. (Ball Studs should face towards the
middle of the unit.) Tighten using 1!2-in wrench.
5/16 - 18
Clip-on Nut
LABELS (iF APPLICABLE)
PrOCeSS:
Appty a tight film of glass cleaner to the surface where
the tabel is to be applied.
Peel the label from the backing and place the tabet in
position.
Check alignment of the label and adjust accordingly.
Hotd the labet in position and squeegee off excess tiquid
with a towet, working from the center toward each end of
the tabel.
Suggested tabet tocation is shown.
2-3/4
Q REMOVING DRAWERS
Empty the drawer.
Futty extend the drawer.
Release
5/16- 18
Bail Stud
install Gas Spring as shown in image below by pushing
the sockets onto Bait Studs (cylinder side up).
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the stides to ride
over the stops). Putt out to remove.
Gas
Spring
Close and open cover to check Gas Springs are properly
installed.
3
Loading ...
Loading ...
Loading ...