Loading ...
Loading ...
Loading ...
3. Move the cutting height lever forward to decrease
the cutting height.
CAUTION: Do not set the cutting height
too low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Stay behind the product.
3. Move the throttle control to the fast speed position.
STOP
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING: Do not twist the starter
rope around your hand.
To use the drive on the wheels (LC
419SP)
• Push the drive bail in the direction of the handlebar.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm / 4 in.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the engine, move the throttle control to the
stop position.
ST
O
P
• If the engine does not stop, disconnect the ignition
cable from the spark plug.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
1434 - 001 -
9
Loading ...
Loading ...
Loading ...