Loading ...
Loading ...
Loading ...
Gentlygrasptheidlerbracketandpivotitupwardto
easetensiononthedrivebelt.SeeFigure7.
Pulley
Auger Pulley
Drive Belt
Figure 7
While holding the idler bracket up, carefully slip the
drive belt off the engine pulley. See Figure 7.
Carefully release the idler bracket and allow itto
pivot downward.
Carefully slip the drive belt off the auger pulley,
freeing itfrom the snow thrower. See Figure 7.
Install the replacement drive belt by following the
preceding steps in reverse order.
Reattach the belt cover with the five hex screws
removed earlier.
ReplacingtheShavePlate
The shave plate is subject to wear and should be
checked periodically. There are two wearing edges and
the shave plate can be reversed after one side wears
out. To replace (or reverse) the shave plate, proceed as
follows:
NOTE: Call 1-800-800-7310 for information regarding
price and availability of Shave Plate Kit 753-0451 or
contact an authorized MTD Service Dealer in your area.
Remove the four carriage bolts and hex lock nuts
which secure itto the snow thrower's auger
housing. Refer to Figure 6.
Install the new shave plate (or reverse the existing
one, if both sides are not yet worn), making sure the
heads of the carriage bolts are on the inside of the
housing. The lock nuts should be on the outside of
the housing.
Adjust the shave plate as instructed in the Making
Adjustmentssection on page 8 of this manual.
Tighten the nuts securely before operating the
snow thrower.
ReplacingtheAuger'sRubberPaddles
The snow thrower auger's rubber paddles are subject
to wear and should be replaced if any signs of
excessive wear is present.
IMPORTANT:Do NOT allow the auger's rubber paddles
to wear to the point where portions of the metal auger
itself can come in contact with the pavement. Doing so
can result in serious damage to your snow thrower.
NOTE: Call 1-800-800-7310 for information regarding
the price and availability of Auger Kit 753-04472 or
contact an authorized MTD Service Dealer in your
area).
To change the rubber paddles, proceed as follows:
Remove the existing rubber paddles by
unthreading the self-tapping screws which secure
them to the auger.
Secure the replacement rubber paddles to the
auger using the hardware removed earlier.
SECTION7: OFF-SEASONSTORAGE
WARNING: Never store engine with fuel in
tank indoors or in enclosed, poorly ventilated
areas where fuel fumes may reach an open
flame, spark or pilot light as on a furnace,
water heater, clothes dryer, or other gas
appliance.
Clean snow thrower thoroughly.
Lubricate as instructed in the Maintaining Your
Snow Thrower section on page 8 of this manual.
Refer to the Tecumseh Engines manual packed
with the snow thrower for detailed instructions
regarding all engine-related storage instructions.
Store the snow thrower in a clean, dry area.
Place blocks under the front of the auger housing
so that the snow thrower is not resting on the
rubber auger paddles. The rubber can become
misshaped if it supports the weight of the snow
thrower for several months of storage.
NOTE: When storing any type of power equipment in a
poorly ventilated or metal storage shed, care should be
taken to rustproof the equipment, especially springs,
cables and all moving parts.
Loading ...
Loading ...
Loading ...