Loading ...
Loading ...
Loading ...
Rinnai 12 GRANADA 252 - REH-252UCH2 - OIM
OPERATION
For trouble free operation, please read the following information carefully.
For your convenience, the controls on your heater are situated under the cover on the top right hand side of the
heater.
All necessary adjustments to the operation of your heater can be made with these controls.
CONNECT GAS AND PLUG INTO POWER POINT
Ignition
Room must be ventilated when this heater is in use.
Release the button.
Press the front control button rmly, this operates the built in
safety device and starts the electronic spark, the centre burner
will ignite. Check that the burner has lit, continue to hold the
button down for about 15 seconds. The spark will continue whilst
the button is held down.
NOTE
If the burner does not remain alight, push the button again and release it, this will
return it to the “OFF” position. Wait 30 seconds, then repeat the ignition procedure.
(The ignition button must be in the “OFF” position before attempting re-ignition).
The burner should glow evenly after a few minutes of operation. If there is a large dierence in the glow, or there
is an unusual amount of ame coming from the top of the burner, contact your Dealer or Rinnai. Graduate burners
shown here.
BURNER
HIGH
MED
IGN
+
LOW
FAN
LOW
OFF
HIGH
Push Front Button
Sharp and blue
Soft and yellow
PILOT
Loading ...
Loading ...
Loading ...