Loading ...
Loading ...
Loading ...
Assemble the bag retainer and the bag frame strap to
thefront edge of the bag bottom. Place the bag retainer
on top and the bag frame strap underneaththe bag
bottom. Fasten together usingsix #10 x 5/8" slotted
screws and #10-32 hex locknuts.Tighten. See figure
12.
FRONT EDGE OF BAG BOTTOM
IMPORTANT: Do not over bend the supportrodsduring
the following step. Over bending will cause the springsteel
rods to loosesupportingtension.
Assemble the two hoppersupport rodsas shown in
figure 15. Place end of rodinto hole in upper hopper
tube and bend rodjust enough to fit bottom end of rod
intoholein bottomhopper tube.
#10-32 x 5/8" SCREW
BAGRETAINER
FIGURE 12
FRAMESTRAP j
HEX
LOCKNUT
• Assemble the frame strap to the lower hopper tube
using two 1/4" x 1-1/4" hex bolts and 1/4" hex lock nuts.
Tighten. See figure 13. FIGURE 15
1/4" HEX
LOCK NUT
FIGURE 13
LOWER
HOPPER
TUBE
\
1/4" x 1-1/4" HEX BOLT
(OUTSIDE)
FRAMESTRAP
• Secure the bag comers over the lowerhopper tube by
snapping the flap to the bag bottomon bothsides. See
figuns14.
Locate (bytouch) the hole in each upper hopper tube,
approximately midway along the side of the bag.
Pierce holes through the stitched bag flaps, aligned
with the holes in both hopper tubes. See figure 16.
PER HOPPER TUBE.
FLAP
FIGURE 16
FIGURE 14
8
Loading ...
Loading ...
Loading ...