Loading ...
Loading ...
Loading ...
13
ENGLISH
SYMPTOM CAUSE FIX
Tool operates but no fastener is driven Wrong size and/or type fastener. Refer to Pin Specifications.
Driver blade stuck down. Refer to "Driver blade continues to get stuck in
down position" symptom, found below.
Nail alignment issue. Sticks of pins should be loaded with the tips at
the front of the magazine. All pins in magazine
should be of equal length.
Debris or jammed pin in nose and/or magazine. Clean magazine and/or nose area and watch
closely for small pieces of broken pins stuck in
the nail channel.
Nail feeding issue. Check that pins are loaded properly.
Tool may be too cold if used below operable
temperatures.
With nose pressed against scrap workpiece,
cycle the tool until it begins firing pins.
Worn or damaged mechanism. See authorized service center.
Driver blade continues to get stuck in down
position
Dirty drive path Clean nose driver path and underside of door.
Jammed pin Clean magazine and/or nose area and watch
closely for small pieces of broken pins stuck in
the nail channel.
Damaged driver blade
Worn or damaged seals
Lack of internal lubrication
See authorized service center.
Jammed pin Wrong size and/or type fastener Refer to Pin Specifications.
Material and fastener length Make sure that the pin type and size are
appropriate for the application and material
selection.
Debris in nose or magazine Clean magazine and/or nose area and watch
closely for small pieces of broken pins stuck in
the nail channel.
Nail feeding issue Check that pins are loaded properly.
Damaged driver blade Order and install replacement driver blade
assembly.
Damaged magazine See authorized service center.
Loading ...
Loading ...
Loading ...