Loading ...
Loading ...
Loading ...
C
D
Fig. 7C
Fig.7D
3. Use a straightedge (C) Fig. 7C, to make the extens on table (B) even with saw table (D),and tighten the two
screws (A) Fig.TB.
4. Attachthe fence slide support{E).,Fi9.7D, to the extension table (B) by using the two 1 1/4" long hex head
screws, _/]6 Iockwashers and 5/lb Tlatwashers (F). Bringscrews up through the two holes ({3) in table
extension and thread them into the two threaded holes (H)onbottom of fence slide support.
NOTE: Do not completely tighten screws at this time.
E
J
K
Rg. 7E Fig. 7F
5. Use a straight edge (C) Fig. 7E, to levelthe fence slide support (E)with saw fence (J), and tighten the two
6. Position the fence slide (K) Fig. 7F,in position on top of saw fence (J)and fence slide support (E).Slide fence
slide (K) back and forth several times to check alignment of fence slide support (E).Make any necessary final
adjustments to fence slide support.
O
I
N
7,
8.
Fig.7G Fig.7H
Remove screw and spring (L) Fig. 7G, and ock handle (M) from locking st_!_ (N).
PLace 1/4" flat washer (O) Fig. 7G, onto locking stud (N) and ir_ert locking stud (N) Fig. 7H, through slot in
fence slide. Thread locking stud into threaded hole in fence slide support (E).
7
Loading ...
Loading ...
Loading ...