Loading ...
Loading ...
Loading ...
13
Troubleshooting guide
PROBLEM CAUSE REMEDY
The appliance does not
switch on.
The appliance is not plugged
into a mains socket.
Make sure the appliance is correctly
connected and press the On/Off
button.
Steam comes out under the
base unit.
The «max» pressure safety
system has opened.
Turn the appliance off immediately and
contact an authorised Braun Customer
Service.
There are some water drops
from the holes in the bottom
of the soleplate.
Water has condensed inside the
tubes because steam is being
used for the fi rst time, or has not
been used for some time.
Press the steam button several times
away from the ironing board. This will
eliminate cold water from the steam
circuit.
Brown coloured fl uid leaks
from the soleplate.
Chemical water softeners or
additives have been poured into
the water tank boiler.
Never pour products into the water
tank. Clean the sole plate with a damp
cloth and rinse the boiler.
The fi rst time the appliance
is turned on, you notice
smoke / smell.
Some parts have been treated
with sealer / lubricant which
evaporates the fi rst time the iron
heats up.
This is normal and it will stop when you
have used the iron a few times.
If the smoke/smell is still present after
turning off the appliance, contact an
authorised Braun Customer Service.
The appliance emits
an intermittent noise
associated with vibrations.
Water is being pumped into the
boiler.
This is normal and no action is needed.
Water tank is empty.
Refi ll the water tank and press the reset
button.
The closure is diffi cult to
unscrew.
Lime scale has made the
closure diffi cult to open.
Turn the cap forcefully. To avoid the
problem, rinse system frequently.
All LEDs are fl ashing. System error
Unplug the system, plug in again
and press the On / Off button. If this
problem is still present, turn the
appliance off immediately and contact
an authorised Braun Customer Service.
Steam comes out from the
closure.
The closure is not tightened
correctly.
Turn off the appliance and tighten the
closure correctly, but not overtighten it.
Note: the closure might be hot.
The closure gasket is damaged.
Turn off the appliance immediately and
contact an authorised Braun Customer
Service.
Ironing system is ready,
but no steam emission from
the iron.
End of water alarm has been
reset without water refi ll.
Refi ll the water tank and press the
steam button several times for 1
minute until pump loads water inside
the system.
Turn off the appliance and wait until it
has cooled down.
The LED
is still on although
water has been refi lled.
The reset button has not
been pressed or has not been
pressed correctly.
Make sure the reset button is pressed
correctly.
Subject to change without notice
5712870072_CareStyle_IS514X_Cinderella_Steamstation_INT.indd 13 08.03.22 10:13
Loading ...
Loading ...
Loading ...