Read all instructions before using this safe.
User Manual Pistol Keypad Safe
©2018 BARSKA®
855 Towne Center Drive | Pomona, CA 91767
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
1/18
BC558
Start
Open pistol safe with emergency keys and install 4 AA
batteries. Pay attention to the polarity of the batteries.
Note: Do not mix new and old batteries.
Register Pin Code
Press and hold the initialization button inside the safe until light
on keypad come on and two beeps heard.
Enter in desired Pin Code(4-6 digits) and press initialization
button again when finished. Then, Pin Code is registered
successfully.
NOTE: Default Pin Code is 1234. Once the Pin Code has been
registered with new Pin Code, the default Pin Code will be
replaced.
Open
Press set pin code and safe should open
Sound Option
Sound On/Off
Press and hold 4 button until light is seen to turn the sound for
the safe on/off.
Mounting
Parts
A. Mounting Bracket
B. Indicator Light
C. Key Pad
D. Key Access
E. Initialization Button
F. Battery Compartment
G. Mounting Area
WARNING
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe, gaining full
access to the safe and contents.
- Store emergency keys in a secure place; NOT inside of
the safe.
- Be aware of the load bearing. Failure to do so can result in
personal injury and/or damage to property. Use appropriate
tools when performing work and always use eye protection.
- When mounting the safe make sure the compartment has
enough space to drop open. The compartment requires gravity
to fully release, always install in a vertical position.
- Keep safe away from children.
NOTE: BARSKA is not responsible if the safe or its contents
gets lost or stolen
The safe can be mounted from the left or right with the
included mounting bracket.
Use proper drill tools and mounting hardware for the type of
surface you are mounting the safe too. Included screws are
designed to be used on wood surfaces.
1. Open the safe with the pin code or key.
2. Unscrew the thumbscrews located on the inside of the safe.
3. Remove the bracket by sliding it down and off of the safe.
4. Use the wall mounting holes on the side or top of the
mounting bracket to mark the desired mounting location.
5. Use appropriate mounting hardware to screw the bracket
into desired location.
6. Slide the safe onto the bracket screw in thumbscrews
located on the inside of the safe.
7. Close the safe
The safe is now ready to be used.
See reverse side for more information
a. Mounting Bracket Hole
b. Thumb Screw Hole
c. Wall Mounting Hole
Mounting Holes Of The Safe
Mounting Holes Of The
Mounting Bracket
c
b
a
b
a
A
D
B C
G
E
F
Inside
Loading ...
