Loading ...
Loading ...
Loading ...
CrisperCoverSupport(somemodels)
TheCrisper Cover Support, located between the two Crisper
drawers, is shipped raised from the liner floor. This prevents
damage to the liner floor during shipping. Once your refrigerator
has been }nstalled in it'sfinal location, the Footof the Crisper
CoverSupportmust be lowered to prevent bowing in the middle
of the Crisper Cover, when food is placed on iL
Adjusting the Foot of the Crisper Cover Support:
1. To lower the Foot, rotate it the clockwise direction until it
rests on the liner floor°
2o To raise the Foot, rotate itin the counterclockwise direction.
Support
-_- Foot
Crisper Cover Support
MEAT PAN (SOME MODELS)
Some models are equipped with a Meat Pan that can
be positioned below any refrigerator shelf° Use this
pan for short term storage of bulk meat items. If
meats are to be kept longer than 1 or 2 days, they
should be frozen.
WINE RACK (SOME MODELS)
The Wine Rack stores bottles of wine, or 2-liter plastic
bottles of juice or soda pop, To install, slide the wine rack
onto the shelf with the curve facing in,,To remove, slide the
wine rack out° Install on either side of a Spill Proof TM shelf
Wine Rack
CONVERTIBLE MEAT KEEPER (SOME MODELS)
The temperature in the Convertible Meat Keeper can be
made colder than the rest of the refrigerator compartment
by using the adjustable air flow control. Foods can be
partially frozen and kept fresh longer than if stored on a
refrigerator shelf. Before placing food in the Convertible
Meat Keeper, {otiow these steps:
o Carefully handle food items with clean hands and always
keep drawer clean.
Store meat or fish in the original wrapper. If necessary,
overwrap in plastic wrap or foil tp prevent drying.
o If food spoifage occurs, disinfect the drawer with liquid
chlorine bleach following label directionso Wash with a
solution of baking soda and water. Rinse with water
and dry,
lJ .,_77
Adiustable Air FIow Control (some models ',
if your refrigerator has an automatic ice maker, it will
provide a continuous supply of ice for normal use.The
automatic ice maker is an optional accessory which may be
installed in most models at any time, Call your tocat dealer
for installation.
After the plumbing connections have been completed, the
water supply valve must be opened. Place the ice container
under the ice maker, pushing it as far back as possible.
Lower the wire signal arm to its "down" or ON position.
Because of new plumbing connections, the first production
of ice cubes may be discolored or have an odd flavor.
These should be discarded until the cubes made are free of
discoloration and taste.
Remember, water quality
determines your ice quality` It is best to
connect the ice maker to water that is
not softened, Chemicals from a mat-
functioning softener can damage the ice
maker, If ice maker is connected to soft
water, ensure the softener is maintained
and working properly`
To stop the ice maker, liftthe wire signal arm until it clicks
and locks in the "up" or OFF position_ The ice maker turns
off automatically when the ice container is full.. If your model
has an adjustable freezer shelf, ptace the shelf so the wire
signal arm will hit the ice when the ice container is full.
Loading ...
Loading ...
Loading ...