Loading ...
Loading ...
Loading ...
KURZWEIL
KS-50A
1. Introduction
Congratulations on your purchase of the KURZWEIL KS-50A.
The KS-50A top quality near field reference monitor has been developed especially for high level
home studios and special project studios. They take 5" near field monitoring speakers to a new level,
boasting an ultra-flat low frequency response and a top quality kevlar 5" driver delivering
unparalleled punch in the low-mid frequency a major improvement over the paper and
polypropylene drivers used in most comparable products. KS-50A is perfect to provide the best
output signal and frequency response 100% matching the installed drivers and cabinet design. KS-
50A is magnetically shielded for desktop operation next to your other electronic equipment without
interference.
2. Basics & Installation
For optimal performance of KS-50A, read the instructions in this manual carefully before using the
speakers.
Unpacking / Handling
To remove the monitor from the carton, it is best to turn the package carefully upside down on the
floor or on a table and then lift the carton up slowly to leave the monitor resting in the packaging
foam. To avoid damage, make sure that you don
monitors. Check the monitor for signs of damage that might have occurred in shipping. In the
unlikely event of damage, please contact the reseller of the product immediately. Be careful when
you remove the packaging foam. Please keep all packing materials.
Connection
High quality XLR balanced or TS unbalanced audio cables are recommended for input connection.
The monitor typically connects to the line level output of a mixing console or computer audio card.
Make sure the power of the monitor is switched off before you connect any audio cables. Also turn
down the volume initially.
XLR balanced connection
Connect the male side of a XLR balanced cable to the balanced XLR input of KS-50A. Make sure
the power cable is connected as well. Setup all speakers (i.e. left / right channels) with the same
type of cable.
TS unbalanced connection
Connect a TS unbalanced cable to the input jack of KS-50A. Make sure the power cable is
connected as well. Setup all speakers (i.e. left / right channels) with the same type of cable.
Loading ...
Loading ...
Loading ...