Loading ...
Loading ...
Loading ...
6
6. INSTALLATION
7. OPERATION
7.1 First use
This refrigerating appliance is not intended to be used as a built-in appliance.
To fix stably, the appliance must be placed on a flat and solid surface. It should not be laid on any soft material.
Choose a location where there is no heat source. Keep the refrigerator away from direct sunlight or other appliance
producing heat.
Choose a dry and well-ventilated place where there is no corrosive air.
In order to improve efficiency of the cooling system and save energy, it is necessary to maintain good ventilati
on
around the appliance for the dissipation of heat. For this reason, sufficient clear space should be available around
the refrigerator.
The appliance is supplied with two plastic spacers. After installation of these spacers, the appliance cannot be pushed
against the wall to maintain proper ventilation. Insert the spacers into the relevant openings on the back of the appliance,
then screw the spacers tightly. Place the appliance against a wall with a free distance that not exceeding 75 mm but
more th
an 50mm.
Before the use of the refrigerator, remove all the packages,
including bottom cushion and foam pads and rubber belts
in the refrigerator.
Adjust the feet and clear the outside and inside of the
refrigerator with warm cloth.
Do not start the refrigerator immediately after vertical
placement. Only start it after 2-6 hours standing to ensure
its proper operation.
To prevent damage to the power cord and any consequence
incidents, the power cord should be not covered by the
refrigerator or other
objects. Before switching on the
refrigerator, please check the voltage range of refrigerator
carefully if the same as that of the power supply.
When the refrigerator is first installed, allow it stabilize at
normal operating temperatures for 2-3 hours prior to
filling it with fresh or frozen foods.
If operation is interrupted, wait for 5 minutes before
restarting.
7.2 Testing
7.3 Temperature control
The fridge is controlled with a temperature control knob
located inside it, towards the upper right‐hand corner.
Adjust the control knob as desired to suit your individual
preference.
In the off position (0) the appliance does not operate (the
cooling system is switched off), but power supply is not
interrupted.
Set the thermostat knob to "3-4"position for a normal use.
The running time and temperature are affected by where the
fridge is located, how often the door is opened and the
temperature of the room the fridge is located in.
When you use the appliance for the first time or after
defrosting, adjust the control knob to the coldest setting for
at least 2 hours before introducing food to be stored, and
then readjust to the middle setting.
Clean the parts of the refrigerator with lukewarm
water on a soft cloth or with a neutral detergent and
with clear water, then wipe them dry.
Notes: Electric parts of the refrigerator can only be
wiped by dry cloth.
Turn the thermostat knob on the "3" position and turn
on electricity. The compressor and the light inside the
refrigerator begin to work.
Close the door and wait 30 minutes. If the temperature
in the freezer compartment decreased obviously, it
shows that the refrigerat
or system works well. When
the refrigerator operates for a period of time, the
temperature controller will automatically set the
temperature on conditions that the door is not too
often opened.
If the above steps are successful, the trial operations
are finished. The refrigerator works normally.
Note:
T
0=off setting
1=cold setting
7=coldest setting
he temperature will impact the storage time of food.
Set the temperature as necessary. Warmer will accelerate
food spoilage and colder will frozen food bad.
Thus food to be wasted.
30cm 30cm
50-70cm
www.linarie.com.au
Loading ...
Loading ...
Loading ...