Loading ...
Loading ...
Loading ...
Page 9
Setting Vertical Angle of Air Flow
While the unit is on, use the SWING/DIRECT
button to set the direction (vertical angle) of
airflow (Dual function button: Left/Right).
1.
Press the SWING/DIRECT button once to
activate the louver. Each time you press
the button, it will adjust the louver by 6°.
Press the button until the direction you
desire is reached (left side of button).
2.
To set the louver to swing up and down
continuously, press and hold the SWING/
DIRECT button for 3 seconds. Press it
again to stop the automatic function.
The horizontal angle of the airflow must be set
manually. Locate the deflector rod (See Fig.B)
and manually adjust it to your preferred direction.
For some units, the horizontal angle of the airflow
can be set by remote control. Please refer to the
Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set the
louver at a high vertical angle for extended periods
of time. This can cause water to condense onto
the louver blade, which will drop to your floor
or onto furnishings. (See Fig. A)
When using COOL or HEAT mode, setting the
louver at a high vertical angle can reduce the
performance of the unit, due to restricted air
flow.
Do not move louver by hand. This will cause the
louver to go out of sync. If this occurs, turn
off the unit and the breaker for a few seconds,
then restart the unit. This will reset the louver.
Fig. A
CAUTION
Do not put your fingers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. B
Setting Angle of Air Flow
Setting Horizontal Angle of Air Flow
•
Unit
Specifications
and Features
Loading ...
Loading ...
Loading ...