Loading ...
Loading ...
Loading ...
7
conditions. Follow the charging procedure.
You may also charge a partially used pack
whenever you desire with no adverse
affect on the battery pack.
5. Foreign materials of a conductive nature
such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic
particles should be kept away from
charger cavities. Always unplug the
charger from the power supply when
there is no battery pack in the cavity.
Unplug charger before attempting to
clean.
6. Do not freeze or immerse charger in
water or any other liquid.
WARNING: Shock hazard. Do not
allow any liquid to get inside charger. Never
attempt to open the battery pack for any
reason. If the plastic housing of the battery
pack breaks or cracks, return to a service
center for recycling.
STATE OF CHARGE INDICATOR
The battery is equipped with a state of
charge indicator. This can be used to
display the current level of charge in the
battery during use and during charging.
It does not indicate tool functionality and
is subject to variation based on product
components, temperature and end-user
application.
Checking state of charge during use:
• Press the state of charge indicator
button (A1).
• The three LEDs (A2) will illuminate,
indicating the percent of charge in the
battery. See chart in Figure A.
• If LED light does not illuminate, charge
battery.
<18%
18% - 45%
45% - 72%
72% - 100%
A
A2
A1
INSTALLING AND REMOVING
THE BATTERY PACK FROM
THE TOOL
WARNING: Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert
battery (5) into tool until an audible click is
heard (Figure B). Ensure battery pack is
fully seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button (6) as shown in
Figure C and pull battery pack out of tool.
B
C
ASSEMBLY INSTRUCTIONS
WARNING: Make certain the battery
is removed before assembly or
disassembly of any parts.
ASSEMBLY TOOLS REQUIRED (NOT
SUPPLIED):
- Phillips Screwdriver
ATTACHING GUARD AND BAIL HANDLE
TO TRIMMER
WARNING: Only use with handle and
guard properly assembled to hedge
trimmer. The use of the hedge trimmer
without the proper guard or handle provided
may result in serious personal injury.
The trimmer is shipped with the guard and
bail handle attached to the trimmer with a
plastic zip tie.
To assemble to trimmer:
• Cut the plastic zip tie.
• Remove the six screws that are partially
run into the trimmer housing (figure D).
D
Loading ...
Loading ...
Loading ...