Loading ...
Loading ...
Loading ...
14
English
Nail feeder
Magazine cover
2
1
NOTE
●
Use nails at least 5 nails remaining.
●
Slide the nail feeder SLOWLY forward.
If the nail feeder is released roughly, it may be stuck
between the magazine and nails, which makes mis-
feeding trouble.
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 8).
DANGER
●
Operators and others in work
area MUST wear safety
glasses with side shields
which conforms to ANSI
Z87.1 specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
●
Only person who have read
and understand this
MANUAL should operate the
Nailer.
●
NEVER point tool at yourself
or others in work area.
●
Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
●
Know and understand what trigger system
you are using.
Please read and understand “METHODS OF
OPERATION” found below.
●
Inspect the Nailer before operating to
determine actuation system.
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
2
)
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
WARNING
●
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back.
Nail feeder
(2) Pull the nail feeder until the concave portion of the
magazine cover clicks.
Concave portion
Nail feeder
Magazine cover
(3)
1
Insert nail strips one by one from above the
magazine.
2
Slide nails forward in the magazine.
Nail strips
Magazine
2
1
(4)
1
While holding the nail feeder adjust the magazine
cover in place.
2
Slide the nail feeder slowly forward until it
contacts nails.
000BookNT65M2(S)USmetabo.indb14000BookNT65M2(S)USmetabo.indb142018/03/1916:17:542018/03/1916:17:54
Loading ...
Loading ...
Loading ...