Loading ...
Loading ...
Loading ...
EN
9
Replacing the interior light
bulb
To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorised Service. The lamp(s) used in
this appliance is not suitable for
household room illumination. The
intended purpose of this lamp is to
assist the user to place foodstuffs in the
refrigerator/freezer in a safe and
comfortable way.
The lamps used in
this appliance have to withstand
extreme physical conditions such as
temperatures below -20°C.
Reversing the doors
Top door
1. Unsc
rew top hinge (1)
.
2. Ca
refully remove the top doo
r
(2).
3. Unsc
rew lower hinge (3
)
.
4.
Remove plastic plugs (7 & 8).
5. Refit top hinge
(1) as lower hinge (16)
on the left hand side.
6. Replace top door (17).
7. Refit lower hinge (3) as top hinge (18)
on the left hand side.
Lower door
1. Unscrew top hinge (4).
2. Carefully remove the lower door (5).
3. Unscrew lower hinge (6).
4. Remove plastic plugs (9 & 10).
5. Refit hinge (4) as lower hinge (11) on the
left hand side.
6. Replace lower door (12).
7. Refit lower hinge (6) as top hinge (13) on
the left hand side.
Refit plastic plugs (7, 8, 9 & 10) into the
screw holes on the right hand side (14,
15, 19 & 20).
However at low ambient temperatures
mentioned above, fridge contents are
likely to freeze, so check and consume
food in the fridge accordingly. When
the ambient temperature returns to
normal, you may change the knob
setting to suit your needs. If the
ambient temperature is below 0°C,
the food in the fridge compartment will
freeze. So, we recommend you don’t
use the fridge compartment in such
low ambient conditions. You can
continue using the freezer
compartment as usual.
4.Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
5.Refer to "Maintenance and cleaning"
section to prepare your appliance for
use.
6.A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the side of the
compressor (see diagram). Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case of
transportation, ensure you locate the
plug in the receptacle provided to
avoid transit damage.
Loading ...
Loading ...
Loading ...