Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center.
PROBLEM
Engine clicks but
will not start
Loss of power
CAUSE
1 Weak or dead battery.
2 Corroded battery terminals.
3 Loose or damaged wiring.
4 Faulty solenoid or starter.
1 Cutting too much grass/too fast.
2 Throttle in "CHOKE" position.
3 Build-up of grass, leaves and
CORRECTION
1 Recharge or replace battery.
2 Clean battery terminals.
3 Check all wiring.
4 Check/replace solenoid or starter.
1 Raise cutting height/reducespeed
2 Adjust throttle control.
3 Clean underside of mower
trash under mower.
4 Dirty air filter.
5 Low oil level/dirty oil.
6 Faulty spark plug.
7 Dirty fuel filter.
8 Stale or dirty fuel.
9 Water in fuel.
10 Spark plug wire loose.
housing.
4 Clean/replace air filter.
5 Check oil level/change oil.
6 Clean & regap or changespark plug
7 Replace fuel filter.
8 Empty fuel tank and refill tank witt-
fresh, clean gasoline.
9 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
10 Connect & tighten spark plug wire
11 Dirty engine air screen/fins.
12 Dirty/clogged muffler.
13 Loose or damaged wiring.
14 Carburetor out of adjustment.
Excessive vibration
15 Engine valves out of adjustment.
1 Worn, bent or loose blade.
2 Bent blade mandrel.
3 Loose/damaged part(s).
Engine continues to
run when operator
leaves seat with atta=
chment clutch engaged
1 Faulty operator-safety presence
control system.
Poor cut = uneven
cutting
1 Worn, bent or loose blade.
2 Mower deck not level.
3 Buildup of grass, leaves, and
trash under mower.
4 Bent blade mandrel.
11 Clean engine air screen/fins.
12 Clean/replace muffler.
13 Check all wiring.
14
15
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
1 Replace blade. Tighten blade bolt
2 Contact a Sears or other qualified
service center.
3 Tighten loose part(s).
Replace damaged parts.
1 Check wiring, switches and
connections. If not corrected,
contact a Sears or other
5 Clogged mower deck vent from 5
build-up of grass, leaves, and
trash around mandrels.
,mm,_
1 Replace blade. Tighten blade bolt
2 Level mower deck.
3 Clean underside of mower
housing.
4 Contact a Sears or other
qualified service center.
Clean around mandrels to
open vent holes.
29
Loading ...
Loading ...
Loading ...