Loading ...
Loading ...
Loading ...
Not for
Reproduction
7
Connect Hoses and Water Supply
NOTICE Use ONLY cold water (less than 100°F).
1. Attach garden hose 50 ft. (15.24 m) maximum) to
water supply and run water through garden hose for 30
seconds to flush the hose of debris. Turn off water.
2. Confirm that water inlet screen (A) is installed in water
inlet coupling (B) lower rear of unit.
NOTICE DO NOT run pump without water supply
connected and turned on.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
3. Attach garden hose (C) to water inlet coupling (B).
Tighten by hand.
4. Attach high pressure hose (D) to unit’s water outlet (E)
located lower front of main unit. Tighten by hand.
5. Attach other end of high pressure hose to the spray
gun. Press red button (F) on spray gun, then insert
end of high pressure hose (G) into gun until it SNAPS
into place. Release red button and make sure
connection is secure.
Connect Wand and Spray Tip
1. Turn ON water, point gun in a safe direction, press
trigger lock button (H), then squeeze trigger to purge
pump system and spray gun of air and impurities.
2. Insert and twist plastic wand (J) into spray gun (K). Once
wand slides into gun, apply further inward pressure to
wand and twist 1/4 turn clockwise until securely in place.
3. Turn OFF water and release trigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.
4. Insert turbo tip (L) into plastic wand (J). Once turbo tip
slides into gun, apply further inward pressure until it
SNAPS into place.
5. To remove turbo tip, press release button (M) and pull
it away from the wand.
Checklist Before Starting Pump Motor
Review the unit’s assembly to ensure you have performed
all of the following.
1. Be sure to read Operator Safety and Operation before
using the electric pressure washer.
2. Check for properly tightened hose connections.
3. Check to make sure there are no kinks, cuts, or damage
to hoses.
4. Provide a proper water supply at an adequate flow.
5. Plug electrical power cord into a dedicated electrical circuit
rated for 120 Volts AC at 15 Amps that is properly installed
in accordance with all local codes and ordinances. Check
that circuit is not used to supply any other electrical needs.
Servicing Of A Double-Insulated Appliance
In a double-insulated product, two systems of insulation
are provided instead of grounding. No grounding means
is provided on a double-insulated product, nor should a
means for grounding be added to the product. Servicing
a double-insulated product requires extreme care and
knowledge of the system, and should be done only by
qualified service personnel. Replacement parts for a double-
insulated product must be identical to the parts they replace.
A double-insulated product is marked with the words
“DOUBLE INSULATION” or “DOUBLE INSULATED.”
The symbol means DOUBLE-INSULATED
APPLIANCE.
KJ
J
M
L
G
F
H
D
E
C
B
A
Loading ...
Loading ...
Loading ...