Loading ...
Loading ...
Loading ...
ENGLISH
11
2. Depress thetrigger.
To operate the tool using the bump actuation
method:
1. Depress thetrigger.
2. Push the contact trip against the work surface. As long
as the trigger is depressed, the tool will drive a staple
every time the contact trip is depressed. This allows the
user to drive multiple staples insequence.
WARNING: Do not keep trigger depressed when tool
is not in use. Keep the trigger lock-off in the locked
position when the tool is not inuse.
WARNING: When the tool’s motor is running, pulling
the trigger or depressing the contact trip will cause a
staple to bedriven.
Preparing the Tool
WARNING: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of thetool.
NOTE: The battery pack is not fully charged out of the
carton. Follow instructions outlined (see Charging
a Battery).
1. Read the Safety Instruction section of thismanual.
2. Wear eye and earprotection.
3. Ensure magazine is empty of allfasteners.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. NEVER use
a tool that has the contact trip restrained in the
actuatedposition.
5. Keep tool pointed away from yourself andothers.
6. Insert fully charged batterypack.
Using the Trigger Lock-off (Fig. H)
WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig.H)
when the tool is not inuse.
WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack from
tool and remove staples from magazine before
makingadjustments.
Each
DEWALT
stapler is equipped with a trigger lock-off
2
which when pushed to the right as shown in FigureH,
prevents the tool from firing a staple by locking the trigger
and bypassing power to themotor.
Fig. H
2
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off whenever any adjustments are made or when
tool is not in immediateuse.
NOTICE: Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
battery life, store battery packs out of the tool or
charger in a cool, drylocation.
Loading the Tool (Fig. I)
WARNING: Keep the tool pointed away from yourself
and others. Serious personal injury mayresult.
WARNING: Always remove battery pack before
loading or unloading staples. Serious personal injury
mayresult.
WARNING: Never load staples with the contact trip or
trigger activated. Personal injury mayresult.
1. Press magazine latch
15
and open sliding magazine
6
fully.
2. Ensure staple is loaded so that crown of staple sits
against inside surface of magazine
6
.
3. Close sliding magazine until the magazine latch
clipssnuggly.
Fig. G
6
15
Unloading the Tool (Fig. I)
WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not inuse.
1. Press magazine latch
15
and open sliding
magazine
6
fully.
2. Tip the tool up until the staples slide freely out of the
bottom of the magazine.
3. Check to ensure no loose staples remain inside
magazine.
4. Close sliding magazine fully.
Dryfire Lock Out Feature (Fig. A)
Tool is equipped with a dryfire lock out feature to prevent
tool from cycling when there are no fasteners loaded. When
no fasteners are visible in the Fastener Window
16
, the
tool is running low on fasteners. If this happens, the tool will
Loading ...
Loading ...
Loading ...