Loading ...
Loading ...
Loading ...
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not hori-
zontal (left to right) when wheels are posi-
;tiodedstr_,ight forward, ='emove Steering
wheel and reassemble per instructions in
the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toeoin and camber are not
adjustable on your tractor. If damage has
occurred to affect the front wheel toe-in or
camber; contact your nearest authorized
service center:
TO REMOVE WHEEL FOR REPAIRS
o Block up axle securely°
, Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).
• Repair' tire and reassemble.
o On rear wheels only: align grooves in
rear wheel hub and axle, insert square
key.
o Replace washers and snap retaining
ring securely in axle groover
° Replace axle cover:
NOTE: To seat tire punctures and prevent
flat tires due to stow leaks, tire sealant
may be purchased from your local parts
dealer, Tire sealant also prevents tire dry
rot and corrosion.
Washers
Retaining
Ring
Axle Cover
'_,, Square Key
(Rear Wheel Only)
TO START ENGONE WlfTH A WEAK
BATTERY
_kCAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around battedes.
If your battery is too weak to start the
engine, it should be recharged. (See
"BATTERY" in t_e MAINTENANCE sec-
tion of this manual)_
If "jumper cables" are used for emergency
starting, follow this procedure:
iMPORTANT; Your tractor Is equipped
with a 12 volt negative grounded system_
The other vehicle must also be a 12 volt
negative grounded system. Do not use
• your tractor battery to start othi_rvehicles:
TO ATTACH JUMPER CABLES -
= Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis_
° Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
, Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery_
TO REMOVE CABLES, REVERSE
ORDER -
o BLACK cable first from chassis and
then from the fully charged battery_
o RED cable last from both battedes_
Positive Terminal
Negative Terminal
ed
Battery
24
Positive
Negative Terminal
REPLACI1NG BATTERV
ACAUTION: Do not short battery ter-
minals by allowing a wrench or any
other object to contact both terminals
at the same time. Before connecting
battery, remove metal bracelets, wrist-
watch bands,rings,etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
o Lift seat pan to raised position and open
batter,] box door:
= Disconnect BLACK battery cable first
then RED battery, cable and carefully
remove battery from tractor:
= Install new battery with terminals in
same position as old battery.
= First connect RED battery cable to posi-
tive (+) terminal with hex bolt and keps
nut as shown_ Tighten securely.
Loading ...
Loading ...
Loading ...