Bestway 1056631USX22 967 Gallons Power Steel 9'3" x 6'5" x 33" Above Ground Pool Set

OWNER'S MANUAL - Page 4

For 1056631USX22. Also, The document are for others Bestway models: 58511E, 58384E, 58388E

PDF File Manual, 10 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
Carefully read, understand, and follow all information in this user manual before installing and
using the Filter Pump. These warnings, instructions, and safety guidelines address some common
risks of water filtration systems, but they cannot cover all risks and dangers in all cases. Always
use caution, common sense, and good judgment when enjoying any water activity. Retain this
information for future use. In addition, the following information can be supplied depending on the
Filter Pump type. Keep the instructions in a safe place. If instruction is missing, search it on the
website www.bestwayusa.com/ourwarranties.
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - TO REDUCE THE RISK OF INJURY, do not permit children to use
this product unless they are closely supervised at all times.
WARNING - RISK OF ELECTRIC SHOCK. Connect only to a grounding type
receptacle. This product is provided with a ground-fault circuit-interrupter. If replacement of the
plug is needed,use only identical replacement parts.
WARNING: The unit is provided with a ground-fault circuit-interrupter (GFCI). To
test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button.
Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If
the GFCI interrupts power to the pump without the test button being pushed, a ground current is
flowing, indicating the possibility of an electric shock. Do not use this pump. Disconnect the pump
and have the problem corrected by a qualified service representative before using.
CAUTION - To reduce the risk of electric shock the pool must be installed no closer
than 6 feet (1.8 m) from any electrical outlet. Do not place portable appliances closer than 5 feet
(1.5 m) from the pool.
WARNING: The pump is not intended to be bonded to the equipotential bonding grid.
DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and
other equipment.
WARNING - To reduce the risk of electric shock, IF FILTER PUMP POWER CORD
BECOMES DAMAGED IN ANY WAY, THE PUMP MUST BE DISCARDED.
WARNING - To reduce the risk of electric shock, do not use extension cord to
connect unit to electric supply; provide a properly located outlet.
CAUTION - This pump is for use with storable pools only. Do not use with
permanently-installed pools. A storable pool is constructed so that it is capable of being readily
disassembled for storage and reassembled to its original integrity. A permanently-installed pool
is constructed in or on the ground or in a building such that it cannot be readily disassembled for
storage.
CAUTION - For continued protection against possible electric shock this unit is to
be mounted to the base in accordance with the installation instructions.
NOTE:
• THERMALLY PROTECTED MOTOR.
• FOR USE WITH SWIMMING POOLS ONLY.
CAUTION: TO ENSURE CONTINUED PROTECTION AGAINST SHOCK HAZARD,
USE ONLY IDENTICAL REPLACEMENT PARTS WHEN SERVICING.
WARNING: RISK OF ELECTRIC SHOCK. CONNECT ONLY TO A GROUNDING
TYPE RECEPTACLE.
CAUTION: THIS PUMP IS FOR USE WITH STORABLE POOLS ONLY - DO NOT
USE WITH PERMANENTLY-INSTALLED POOLS.
CAUTION: CONNECT ONLY TO GROUNDING TYPE RECEPTACLE PROTECTED
BY A CLASS A GROUND FAULT CIRCUIT INTERRUPTER.
CAUTION: FOR CONTINUED PROTECTION AGAINST POSSIBLE ELECTRIC
SHOCK THIS UNIT IS TO BE MOUNTED TO THE BASE IN ACCORDANCE WITH THE
INSTALLATION INSTRUCTIONS.
WARNING - RISK OF ELECTROCUTION
- Connect Only To Properly Grounded Outlet. Do Not Remove Ground Pin.
- Inspect Cord Before Using – Do Not Use If Cord Is Damaged.
- Keep Ground-Fault Circuit-Interrupter Dry And Off The Ground.
- Do Not Touch Plug With Wet Hands.
- Double Insulated – When Servicing Use Only Identical Replacement Parts.
- Read Instruction Manual Before Using.
DO NOT REMOVE THIS TAG
SAVE THESE INSTRUCTIONS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
WARNING: Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
POOL SUCTION FITTING INSTRUCTIONS
When installing and using this equipment, basic safety precautions shall always be followed,
including the following:
IMPORTANT SAFETY INSTRUCTIONS
READ, FOLLOW, AND UNDERSTAND
ALL INSTRUCTIONS AND WARNINGS.
Any modification that increases the flow rate of the circulation system shall require re-evaluation
of the cover/grate and sump to ensure that the flow rating of the Suction Outlet Fitting Assembly
(SOFA) is not exceeded.
• Missing, broken, or cracked cover/grates, sumps, mud-frames, or any other SOFA component
shall be replaced before bathers are allowed to use the pool.
• Loose cover/grates shall be reattached before bathers are allowed to use the pool.
• Replace suction fittings every 2 years.
The use of adhesives or other attachment methods that prevent access to suction piping or SOFA
components requiring periodic servicing is prohibited.
• Refer to the following diagram for each SOFA component part instructions:
- Any field modification made to a SOFA not authorized by the manufacturers installation instructions
shall void the SOFA certification.
- No modification shall be made to a SOFA structure or flow path unless the new configuration
has been certified as new SOFA.
- Cover/grates and all other SOFA components shall be replaced at or before the end of their service
life and that service life begins the month and year in which a SOFA component is installed with
or without water.
• Winterizing instructions. Dry the suction fittings completely, and store the product in a dry room
at a storage temperature of 15ºC ~ 40ºC.
• Use the screwdriver (not included) to disassemble the suction fitting to clean or service.
• Cover/grate, including fasteners, shall be observed for damage or tampering each operational
day.
• Missing, broken, or cracked cover/grates shall be replaced before bathers are allowed to use
the pool.
4
Loose cover/grates and associated components shall be
reattached before bathers are allowed to use the pool.
SOFA components and fastener receptacles shall be clean
and free of debris or obstructions during installation of
cover/grate and fasteners.
• Remember to hand-check cover/grate for snugness to
the sump/frame after installation.
• Before using the product, please check the integrity of
the head of the suction fitting. If the product is broken,
cracked, or the color has significantly faded, please do
not use it.
All SOFAs shall be installed in accordance with the
manufacturers installation instructions.
No modification shall be made to a SOFA structure or flow path unless the new configuration has
been certified to the original SOFA.
These SOFA-configuration specific flow ratings NOT be exceeded at any time the pool is open
to bathers.
Cover/grates, when installed, shall not protrude more than 2 in. (51 mm) from the finished surface
of the pool in which the SOFA is installed.
Please research and download General Certificate of Conformity through
www.bestwayusa.com
SAVE THESE INSTRUCTIONS
Loading ...
Loading ...
Loading ...