Loading ...
Loading ...
Loading ...
CleanTheBattery
Clean the battery by removing it from the unit and
washing with a baking soda and water solution. If
necessary, scrape the battery terminals with a wire
brush to remove deposits. Coat terminals and exposed
wiring with grease or petroleum jelly to prevent
corrosion.
BatteryFailures
Some common causes for battery failure are: incorrect
initial activation, undercharging, overcharging,
corroded connections, freezing. These failures do not
constitute warranty.
Tires
Recommended operating tire pressure is
approximately 10 p.s.i. Maximum tire pressure under
any circumstances is 30 p.s.i. Equal tire pressure
should be maintained on all tires.
When installing a tire to the rim, be certain rim is clean
and free of rust. Lubricate both the tire and rim
generously. Never inflate to over 30 p.s.i, to seat beads.
WARNING: Excessive pressure (over 30
p.s.i.) when seating beads may cause tire/rim
assembly to burst with force sufficient to
cause serious injury.
BeltRemovalAndReplacement
WARNING: Be sure to shut the engine off,
remove ignition key, disconnect the spark
plug wire(s) and ground against the engine to
prevent unintended starting before removing
belt(s)
NOTE: Figures 22, 26 and 27 are shown with the unit
tipped up for clarity. It is not necessary to tip the unff to
remove the belts.
However, if tipping the unit is desired, remove the
battery from the unit. To prevent gasoline leakage,
drain the gasoline, or remove the fuel tank cap, place a
thin piece of plastic over the neck of the fuel tank and
screw on the cap. Be certain to remove the plastic when
finished changing the belts. Block unit securely.
DeckBelt (38" And 42" Decks)
Place the lift lever in the engaged (all the way
forward) position.
Disconnect the spring which is attached to a
bracket on the transaxle, inside the right rear wheel.
Use a spring puller or other suitable tool.
NOTE: When reassembling, make certain belt keeper
pins are assembled in the same locations from which
they were removed. See Figure 22.
Place the lift lever in the BLADES STOP position.
Remove the belt keeper pins from the lower frame.
See Figure 22.
Unhook the deck belt from the engine pulley.
Place the lift lever in the engaged (all the way
forward) position.
Disconnect the stabilizer plate from the stabilizer
shaft assembly by removing the hairpin clips and
flat washers and sliding out the rod. Refer to Figure
13.
Belt Keeper Pins
Engine
Figure 22
Disconnect the sixdeck links by removing the
hairpin clipsand flat washers.
Place the lift lever in the BLADES STOP position.
Slide the deck from beneath the lawn tractor.
Remove the belt guards at each deck pulley by
removing the self-tapping screws. See Figure 23.
Self-Tapping Stabilizer Belt
Plate Guard
Belt Guard
Figure 23
Remove and replace the belt, reassemble following
the instructionsin reverse order.
Deck Belts (46" Deck)
Place the lift lever in the engaged (all the way
forward) position.
Disconnect the spring which is attached to a
bracket on the transaxte, inside the right rear wheel.
Use a spring puller or other suitable tool.
21
Loading ...
Loading ...
Loading ...