Loading ...
Loading ...
Loading ...
Lap Times
A lap time is the time elapsed during a specific
lap or segment. Lap times are recorded
internally by the watch. The watch displays the
elapsed time of the current lap.
E
Start
E
Lap 1
E
A
Goal
Lap 2
Lap 3
Note
●
Lap times can be viewed with EDIFICE
Connected after measurement is
complete.
l
Viewing Stopwatch Data
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Getting Ready
Enter the Timer Mode.
l
Navigating Between Modes
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
1. Hold down (A) for about two seconds.
Release the button when the hour digits
start to flash.
Hours
2. Use (B) and (E) to change the timer hours
setting.
3. Press (D).
This causes the minutes digits to flash.
Minutes
4. Use (B) and (E) to change the timer
minutes setting.
5. Press (D).
This causes the seconds digits to flash.
Seconds
6. Use (B) and (E) to change the timer
seconds setting.
7. Press (A) to exit the setting screen.
Using the Timer
1. Use the operations below to perform a
timer operation.
A
E
E
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (A).
2. Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving Function
Getting ready
Enter the Alarm Mode.
l
Navigating Between Modes
Operation Guide 5582
11
Loading ...
Loading ...
Loading ...